Resample Master Output (or track outs)

My last thread on this topic was misunderstood as redundant and now it’s locked so I can’t explain. The site is also glitching so I can’t open up Sandroid’s profile using Chrome on iOS to message them.

Please note: This is not the same as printing MIDI edits from the perform page into a new sequence, it is not the same as being able to record perform page MIDI edits to the sequencer.

This is resampling the master outs as audio using the internal sampler.

What is the problem?

Yes, a PART of the problem is that users cannot fully utilize the brilliant Perform page when composing. I had mentioned that resampling the master buss could be a workaround for these issues but the use cases are not limited to utilization of the Perform page.

But it is not JUST that.

Users cannot resample the master outs, nor can they resample an individual track or instrument out being run through the master buss and it’s master buss effects.

What do you want to achieve?

Resampling the Tracker’s master output (or other internal outs such as track, instrument, etc) using the internal sampler.

Are there any workarounds?

Users may only do this with a second device recording the master output, then either play that back into the inputs or else shut down tracker, take out the SD card, and then load the recordings onto the SD. Both of these workarounds are horribly disruptive in practice.

Any links to related discussions?

Not really no

Any references to other products?

All other DAWs and samplers basically.

1 Like

Sorry Dylan, this isn’t feasible at this time for hardware reasons as the master buss effects are on the codec.

Hi Mitch!

Would it be possible to resample without using the master effects? While that would be nice is it far from the only reason to resample.

I apparently jumped the gun on that one. :laughing: I apologize :pray:

For completeness sake here is the link to the initial request:

All good. That explanation was confusing anyway. It’s for the best.

1 Like