Synth bug : Filter keyboard tracking parameter not working

Synth
1

Use V1.1 the official release

  1. Pick a Synth that has keyboard tracking parameter
  2. Choose init patch
  3. Engage an LPF put the cutoff frequency to 200hz
  4. Change the keyboard tracking from 100 to 0
  5. Play any note no changes to the sound, even changing from 100 to 0 does not change the cutoff
2

Hey there @george-8461. Welcome back :slight_smile:

I’m not sure I am following you; You mention putting the Tracking from 100-0. If it’s set to 0, then you shouldn’t hear any difference as you are essentially turning off the Key Tracking.

Could you please elaborate? Thanks!

3

Sorry for not being clear. I wish you could demonstrate an example where I see any effect of this parameter. Because I’ve tried a lot and couldn’t hear difference on any synth engine that has this feature. If possible can you write a few steps how I would hear this feature working ?

The 100 to 0 example I used was just me trying to simplify how to reproduce it without a need to upload video etc. In other words if I change this parameter and the Cutoff is set to 200Hz I should be able to “hear” the change while playing the same note (C5 for example) Approaching 100 with the keyboard tracking the Cutoff should go to 2kHz right ?
Thanks