Bug Description
I recently worked on an ambient track and reduced the tempo to 10 BPM for it. A strange quirk occurred, which can also be reliably reproduced. It happens, when trying to play a pattern chain at such a low BPM: When you start Playback with “play chain” Play+ skips the first pattern. If the first pattern is played ‘normally’ and the chain playback is activated afterwards, the pattern finishes playing before transitioning to the next one, as it should.
It’s not a dealbreaker but still a bit annoying. However, it might also be a symptom of a deeper issue at very slow tempos. I’d be very grateful if this could be fixed.
Steps to Reproduce
- Create a new project
- Set the tempo to 10 BPM
- Create two patterns next to each other
- Select the first pattern
- Activate playback with [Shift] to engage play chain mode
Occurrence / Frequency
Always
Found in Firmware
- Version: 1.1.0
- Build: 1708
Attachments
–