Arp & Sequencer not working when using external midi

Arp & Sequencer not working when using external midi. This is more than a tad disappointing. Am I missing something or is this the current way it is?

Working here arp and sequencer. Using OXI One as the external sequencer

My fault for not explaining well… It is not working when sending out. The keyboard function works but then the arp & sequencer do not seem to.

No worries. I was able to send midi out to the Roland S1 with ARP and the Sequencer from the Synth working on the Roland.

in my settings under Midi, I have Clock In: Internal, Transport In: off, Cloud out: midi out jack.

for cable, the supplied Polyend type B 3.5 mm to 5 pin midi, connected to 5 pin midi to a type A 3.5 adapter into the Roland.

I have had it work, but not consistently. same settings on my end. Have even reinstalled the firmware.

I’m pretty sure the issue here right now is the Clock setting. If you set it to external, you’re probably not getting the Arp/Seq to trigger, but when set to the internal clock, it does.

@TSM would like to know if that boils down to your case. It’s also most likely why it’s working for @TheKrazyWabbit, as he has his clock also set to internal.

I’m having the same problem, I think. I’m using a Novation Circuit Tracks as a midi controller. I’m able to trigger single notes just fine on the blue track (local mode off)but something strange happens on the yellow track. My yellow track has an arpeggiation. Not only will it not work at all with local mode switched off, but it doesn’t seem to be playing the arpeggiation, or maybe it’s just not the correct arpeggiation, because it does seem to play a few notes. Any luck with this on your end?

I’m thinking about getting one of these, especially since they just came out with a Oxi One mk2… prices should drop on the used market, or if they don’t I might just get the mk2. I’ve also considering the Hapax, but, talk about big money. I don’t have any true analog synths, but I have about five digital analog modeling synths. Would you recommend the Oxi One? When controlling the Polyend Synth, how many channels do you use? Do you have to use up three of the channels if you want to control all three synths, or can you stack them on one pattern somehow? Do you have any videos?